Quote:
|
Originally Posted by ph33r_j0
I having some problem getting kismet_drone working on my wrt54gs the drives HyperWRT (openWRT was to much configure for me  ). I'm getting this error:
# ./kismet_drone -f kismet_drone.conf
Blah, Blah, Blah
Source 0 (wrt54g): Opening wrt54g source interface eth1...
FATAL: pcap reported netlink type 1 (EN10MB) for eth1. This probably means you're not in RFMON mode or your drivers are reporting a bad value. Make sure you have the correct drivers and that entering monitor mode succeeded.
#
regards |
I have had the same problem with more recent versions of the Sveasoft firmware. It looks like you have to set the AP into monitor mode first. I haven't hade any time to figure out how to do this.
__________________
"Yeah," said a voice from under the table, "you go to pieces so fast people get hit by the shrapnel."
|