warnockm

dmesg after insert:

pccard: PCMCIA card inserted into slot 0
pcmcia: registering new device pcmcia0.0
eth2: Hardware identity 0001:0001:0004:0000
eth2: Station identity 001f:0001:0006:0010
eth2: Firmware determined as Lucent/Agere 6.16
eth2: Ad-hoc demo mode supported
eth2: IEEE standard IBSS ad-hoc mode supported
eth2: WEP supported, 104-bit key
eth2: Station name "HERMES I"
eth2: ready
eth2: index 0x01: , irq 3, io 0x4100-0x413f
ADDRCONF(NETDEV_UP): eth2: link is not ready
eth2: New link status: Connected (0001)
ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
eth2: no IPv6 routers present

dmesg after kismet dies:

ADDRCONF(NETDEV_UP): eth2: link is not ready
device eth2 entered promiscuous mode
audit(1155275209.263:5): dev=eth2 prom=256 old_prom=0 auid=4294967295
hermes @ 00014100: Timeout waiting for command 0x0002 completion.
eth2: Unable to disable port while reconfiguring card
eth2: Resetting instead...
eth2: New link status: Disconnected (0002)
eth2: New link status: Connected (0001)
ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready

kismet dies with this message:

FATAL: Failed to set channel 7 16: Device or resource busy
Terminating.
Didn't detect any Cisco Discovery Packets, unlinking cisco dump
Didn't see any weak encryption packets, unlinking weak file
Sending termination request to channel control child 3110...
Waiting for channel control child 3110 to exit...
Kismet exiting.

I'm running Fedora FC5 w/ the original orinoco drivers (0.15).