Hi,
I'm running airodump/aircrack on an orinoco oem without problems, really good work
But I have problems with a prism based pci card. I'm using the hostap driver version 0.2.4. When I start airodump, I just get the status bar (essid etc.) but nothing else. The cursor runs from left to right, that's all. I have to terminate airodump with ctrl+c. Then I get a segmentation fault.
I set the monitor mode as follows:
iwconfig wlan0 mode Monitor channel 9
iwpriv wlan0 monitor_type 1
Capturing with kismet works fine. So I don't think the driver or the firmware is the reason. Any ideas?
Thanks in advance.
madjerk