Net-stumped

skid · 08-25-2005

I have 2 A.P.’s (WRT54G & WAP54G) and have NS 4.0 installed on 3 computers, each one displays different information. I realize the Aironet 350 is not on “the list”. But why is only 1 A.P. listed on the other?
#1 IBM T20 Laptop with a Cisco Aironet 350 card: NS 4.0 worked at first, now it only shows “no active A.P.’s”
#2 HP Pavilion Laptop with a Linksys WPC54G: NS 4.0 only shows the WAP54G and its SSID.
#3 Desktop with a Linksys WUSB54G adaptor: Shows both A.P.’s and detailed information.

Israel Torres · 08-25-2005

Try switching the cards around and see if you get different results, also if you are using something other than WZC to configure your card exit or disable it since it may using something other than "ANY"

Israel

08-25-2005	#1 (permalink)
skid Registered Member Join Date: Aug 2005 Posts: 1	Net-stumped I have 2 A.P.’s (WRT54G & WAP54G) and have NS 4.0 installed on 3 computers, each one displays different information. I realize the Aironet 350 is not on “the list”. But why is only 1 A.P. listed on the other? #1 IBM T20 Laptop with a Cisco Aironet 350 card: NS 4.0 worked at first, now it only shows “no active A.P.’s” #2 HP Pavilion Laptop with a Linksys WPC54G: NS 4.0 only shows the WAP54G and its SSID. #3 Desktop with a Linksys WUSB54G adaptor: Shows both A.P.’s and detailed information.

08-25-2005	#2 (permalink)
Israel Torres Log Them All... Join Date: Jul 2005 Location: California Posts: 209	Try switching the cards around and see if you get different results, also if you are using something other than WZC to configure your card exit or disable it since it may using something other than "ANY" Israel __________________ The Chronicles of a Wardriver Log Them All... ... Let WiGLE Map Them Out * WiGLE 200K Club Member! * Tools: [ macitup / router configuration / FTard Decoder Ring / SuCKLE/ CheckNS1 / NSQSelect ]

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode