Orinoco monitor mode.

godlike · 05-13-2002

I have my redhat 7.3 with lucent orinoco patched for the monitor mode, but it kicks itself out of monitor mode. I do a iwpriv eth1 monitor 2 11 do a ifconfig -a, it is fine, I try to run airsnort or wellenreiter 1.1 and exit either program and do a ifconfig -a it is back in ethernet mode. Anyone have this problem? Is there a fix?

Thanks...

sh0nuff · 05-22-2002

On airsnort.shmoo.com they said you had to downgrade or maybe upgrede you firmware on the card.. He said he runs 7.52 with no prob, so therfore im running 7.52 with no probs. He said any other firmware other than that would knock the card out after a few packets. So try to change firmware to 7.52.

Hope it helps

killyt

jeffrowe · 05-23-2002

For those of you running Redhat 7.3 I have some questions...

Did you install RH with the card in the machine?

Did you download all the 'Errata' from Redhat including the new 2.4.9-18-4 Kernel?

Which version of PCMCIA-Cs did you use?

Does it matter that the KERNEL-PCMCIA-CS version is version 3.1.27 and the PCMCIA-CS is 3.1.33?

When the card is installed and any point in the install process... there are no LED's lit on it at all and it occasionally locks the system up... Also if the Lucent Godl card is in the system when I boot it, it will not completely boot up... Any Ideas?

05-13-2002	#1 (permalink)
godlike Registered Member Join Date: May 2002 Posts: 20	Orinoco monitor mode. I have my redhat 7.3 with lucent orinoco patched for the monitor mode, but it kicks itself out of monitor mode. I do a iwpriv eth1 monitor 2 11 do a ifconfig -a, it is fine, I try to run airsnort or wellenreiter 1.1 and exit either program and do a ifconfig -a it is back in ethernet mode. Anyone have this problem? Is there a fix? Thanks...

05-23-2002	#3 (permalink)
jeffrowe Registered Member Join Date: Apr 2002 Location: Northern Suburbs, Chicago, IL Posts: 142	REDHAT 7.3 w/ Lucent Questions For those of you running Redhat 7.3 I have some questions... Did you install RH with the card in the machine? Did you download all the 'Errata' from Redhat including the new 2.4.9-18-4 Kernel? Which version of PCMCIA-Cs did you use? Does it matter that the KERNEL-PCMCIA-CS version is version 3.1.27 and the PCMCIA-CS is 3.1.33? When the card is installed and any point in the install process... there are no LED's lit on it at all and it occasionally locks the system up... Also if the Lucent Godl card is in the system when I boot it, it will not completely boot up... Any Ideas? __________________ -Jeffrowe

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-22-2002	#2 (permalink)
sh0nuff Registered Member Join Date: May 2002 Location: Woodbridge VA Posts: 6	On airsnort.shmoo.com they said you had to downgrade or maybe upgrede you firmware on the card.. He said he runs 7.52 with no prob, so therfore im running 7.52 with no probs. He said any other firmware other than that would knock the card out after a few packets. So try to change firmware to 7.52. Hope it helps killyt