![]() |
|
|||||||
| Register | Search | Today's Posts | Mark Forums Read |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#1 (permalink) |
|
Registered Member
Join Date: Feb 2003
Posts: 3
|
Pigtail on a Cisco 352 w/ dual MMCX jacks?
I recently orderd a pigtail that said it was for a Cisco card..However when I got it, the end of the pigtail didnt fit into the MMCX jacks on the card.. I measured the diameter of the both the inside hole of the card and the diameter of the pigtail..
Card appx: .110 Thousandths of an inch or 2.8 mm the Pigtail appx: .138 Thousandths of an inch or 3.5 mm So there is no way that the pigtail could fit into the MMCX jack..I'm not 100% sure on this But I thought that the end of the pigtail would just plug into the card? So did I get sent the wrong pigtail or am I missing something? thanks
__________________
FuR |
|
|
|