Soldering external antenna on Belkin Wireless usb network adapter G

05-17-2005

Hi,
anyone could show, if is possible, where attach an external antenna on the Belkin Wireless usb network adapter G (FCCID: K7SF5D7050(A))

On request I can post more detailed photos.

Thanks in Advance

wrzwaldo · 05-17-2005

Before you post any more pictures...

http://www.netstumbler.org/showpost....69&postcount=2

Lone Flanger · 05-20-2005

Most likely that little PCB trace in the top picture, on the far right side where the trace loops underneath that hole.

Ground it to wherever you can find a ground on the PCB.

Tholek · 05-21-2005

Looking at the unused area of the pcb, you could probably notch it back enough to get an end launch jack of some type on there. I'd sooner try that, than to directly solder a pigtail end to the board.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-17-2005	#2 (permalink)
wrzwaldo I amuse you? Join Date: Dec 2003 Posts: 9,147	Before you post any more pictures... http://www.netstumbler.org/showpost....69&postcount=2

05-20-2005	#3 (permalink)
Lone Flanger Registered Member Join Date: May 2005 Posts: 6	Most likely that little PCB trace in the top picture, on the far right side where the trace loops underneath that hole. Ground it to wherever you can find a ground on the PCB.

05-21-2005	#4 (permalink)
Tholek Registered Member Join Date: Nov 2004 Posts: 17	Looking at the unused area of the pcb, you could probably notch it back enough to get an end launch jack of some type on there. I'd sooner try that, than to directly solder a pigtail end to the board.