Streaming data question

Stumblebum · 05-20-2002

I'm using WAP11's to stream jpg files. the stream is interupted when apparently the AP stobes the beacon and synchonises everybody. (current;y 2 WAP11's as clients for the streaming video). Is there any way to disable the beacon to eliminate the glich? or will my network get out of sync and quit until I reload the AP parameters?

Stumblebum

Thorn · 05-20-2002

Stumblebum,
I'm not quite clear on this, but are the WAP11s bridging two networks (Point-to-Point), or acting as a client for a third AP (Point-to-MultiPoint)?

SWAG: If they are bridged to each other (PtP) you may be able to play with the firmware settings, and eliminate the beacons. In a PtMP setup, I believe the beacons are need to sych everything.

Cheers,

Stumblebum · 05-21-2002

These are pt to multipt mode. I can go to either AP od brg mode (linksys multipoint brg) to do this. I figured I would need to maintain the sync with more than 2 points inn the system.

Thanks

05-20-2002	#1 (permalink)
Stumblebum Street Stumbler Join Date: May 2002 Posts: 27	Streaming data question I'm using WAP11's to stream jpg files. the stream is interupted when apparently the AP stobes the beacon and synchonises everybody. (current;y 2 WAP11's as clients for the streaming video). Is there any way to disable the beacon to eliminate the glich? or will my network get out of sync and quit until I reload the AP parameters? Stumblebum

05-20-2002	#2 (permalink)
Thorn Did you do the math? Join Date: Apr 2002 Location: Villa Straylight Posts: 10,361	Stumblebum, I'm not quite clear on this, but are the WAP11s bridging two networks (Point-to-Point), or acting as a client for a third AP (Point-to-MultiPoint)? SWAG: If they are bridged to each other (PtP) you may be able to play with the firmware settings, and eliminate the beacons. In a PtMP setup, I believe the beacons are need to sych everything. Cheers, __________________ Thorn "Read Altas Shrugged. Compare it to today. Repeat as necessary"

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-21-2002	#3 (permalink)
Stumblebum Street Stumbler Join Date: May 2002 Posts: 27	These are pt to multipt mode. I can go to either AP od brg mode (linksys multipoint brg) to do this. I figured I would need to maintain the sync with more than 2 points inn the system. Thanks