Posted: Thu Sep 22, 2005 6:28 pm
renderman,
I'm on step six of your guide.
When I try to run the drone, I get:
I'm guessing I messed up on step three where I was supposed to edit the kismet_drone.conf file?!
I'm on step six of your guide.
When I try to run the drone, I get:
Using alternate config file: /etc/kismet_drone.conf
Suid prov-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Disabling channel hopping.
Soutce 0 (Kismet-Drone): Enabling monitor mode for wrt54g source interface eth2 channel 0...
Source 0 (Kismet-Drone): Opening wrt54g source interface eth2...
FATAL: ioctl: No such device
I'm guessing I messed up on step three where I was supposed to edit the kismet_drone.conf file?!