cybergibbons wrote:...
The card is a D-Link DWL-G650 Hardware Revision C3, ("Ethernet controller: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01)" from lspci). I've seen reports than the C2 revision works fine with aireplay.
hi there, greeting to all, this is my first post in this forum.
cybergibbons, i hv a card (D-Link DWL-G650 rev c3) which is simliar with urs one (i think).i'd installed the madwifi-cvs driver for the card and everything works fine for me till now.But i'm having trouble whenever i wan to run the airodump with my card.
here is the problem that i encounter:
1)b4 running the airodump, the iwconfig shows the correct ESSID and it's connected to the access point in G mode.
2)after tat i change my card to B mode:
iwpriv ath0 mode 2 channel 6
ifconfig ath0 up
3)then i switch my card to monitor mode as requested by the aircrack documnetation:
iwconfig ath0 mode monitor
ifconfig ath0 up
and the problem happened here, when i 'ifconfig ath0', the H/W address appears to be invalid:
H/w add:00-13-40-9C-1B-4C-00-00-00-00
and also the 'iwconfig ath0' shows me tat the card is disconnected from my access point.
...
IEEE 802.11b
Mode:Monitor
ESSID:00:00:00:00:00:00
Bit rate:0 Mbps
...
4)Ok, after setup all the things, i started my airodump, n it's running, but it caputers the IV's data slowly without connecting to any station...????
since you r using the same card with me, so i need your advice to solve this problem and how u configure your card to make it works with airodump ...
i really appreciate for your help !!