Well I have a SENAO NL-2511CD EXT2 Prism 2.5 Wireless Card I am using BackTrack 2 Final I boot up and log in and it in and with in the shell I type kismet and get
Server options: none
Client options: none
Starting server...
Waiting for server to start before starting UI...
Suid priv-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Enabling channel hopping.
Enabling channel splitting.
FATAL: No packsources were enabled. Make sure that if you use an enablesource line that you specify the correct sources.
but then I got to K and then blacktracks then radio network and so on and get to Kismet and the shell pops
eth1 Broadcom bcm43xx
and then a window saying I have more then one network adapter available
eth1
eth 2
I choose eth 2
and then
eth1 Broadcom bcm43xx
eth2 HermesI orinoco (monitor mode enabled)
the shell goses and turns eth 2 to into montor mode and then kismet load GUI and I seen my networks from that point on can I tried to continue
new shell
iwconfig eth2 mode monitor
bt ~ # airodump -ivs cap1 -channel 11 eth2
-bash: airodump: command not found
bt ~ # airodump -ivs cap1 -channel 11 eth2
then I tired starting Airodump like I did with Kismet and the shell open and
Airodump-ng 0.7 r214 - (C) 2006 Thomas d'Otreppe
Original work: Christophe Devine
http://www.aircrack-ng.org
usage: airodump-ng <options> <interface>[,<interface>,...]
then showed option and I will not list them but
bt ~ # airodump -ivs cap1 -channel 11 eth2
bash: airodump: command not found
Is this the right command because I was not sure if thats the right command or not
Help
Ram360 Thank You